Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 1154)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1138 ￭￭￭￭￭￭￭￭ tiamo 2.1 (ProcessLab)
￭ RECEIVE - Properties
Command variables
The following command variables are generated in the method run by the
command RECEIVE and can be used in formulas under the designation
'Command name.Variable designation':
Identifi-
cation Description
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command has
not ever been started
.FIN Command status; 1 = Command has been ended at
least once, 0, invalid (variable not available) = Command
has never been ended
.TOU Timeout status: 1 = Max. waiting time expired; 0 =
Max. waiting time not expired
5.6.9.5.2 RECEIVE - Properties
Dialog window: Method ▶ RECEIVE ▶ Properties... ▶ RECEIVE - 'Command name'
Command name
Name of the command.
Input 25 characters
Wait for event/status
Selection Wait until all conditions are met | Wait until one
of the conditions is met
Default value Wait until all conditions are met
Wait until all conditions are met
Waits until all conditions listed in the table below are fulfilled.
Wait until one of the conditions is met
Waits until one of the conditions listed in the table below is fulfilled.
[New]
Opens the dialog window Wait for event/status for entering a new event
message which is to be waited for (see Chapter 5.6.9.5.3, page 1139).
Note
A maximum of 10 event messages can be entered.