Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 1506)

8.4 Manual Control - Functions ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1490 ￭￭￭￭￭￭￭￭ tiamo 2.1 (ProcessLab)
[Measuring]
Start measuring of the intensity. The parameters defined will be used.
8.4.5.4 Measure - Sample spectrum
Program part: Manual Control
Here a sample spectrum can be measured and displayed.
Note
Before a sample spectrum can be measured, a reference spectrum has to
be recorded in a determination by a spectrometer.
The parameters Start wavelength, End wavelength, Integration
time, Averaged spectra and Smoothing are read out of the reference
spectrum and displayed, they cannot be modified.
[Measure]
Start measuring of the sample spectrum. The parameters defined will be
used. Only active, if a reference spectrum is available.
8.4.6 ProcessLab functions
8.4.6.1 ProcessLab functions - Overview
Program part: Manual Control
If in the subwindow for the device selection, an IO controller or a stepping
motor is selected, then the device tree will be extended by the connected
in- and outputs and the stepping motors.
ProcessLab functions
The functions depend on the selected entry in the device tree:
￭ (see Chapter 8.4.6.2, page 1490)
￭ (see Chapter 8.4.6.3, page 1492)
￭ (see Chapter 8.4.6.4, page 1498)
￭ (see Chapter 8.4.6.5, page 1499)
￭ Stepping motors
￭ Multi-port valve
8.4.6.2 Digital inputs
Program part: Manual Control