Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 370)

4.8 Curves subwindow ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
354 ￭￭￭￭￭￭￭￭ tiamo 2.1 (ProcessLab)
undone with a double-click on the section of the graph or with the context-
sensitive menu command Show All.
Note
When a new determination is selected the complete curve is always
shown, i.e. the zoom range is not retained when the determination is
changed.
Curves can be copied into the clipboard with the context-sensitive menu
command Copy graphics.
Show monitoring report
With the context-sensitive menu item Monitoring report... in the curve
window the dialog window Monitoring report - 'Command name'
opens for displaying the measuring point list with the selected curve.
The column Monitoring is displayed as default for STAT and DOS com-
mands and can contain the following entries:
Selection _Meas.v. | ¯Meas.v. | _Dos.r. | ¯Dos.r. | _Temp. |
¯Temp. | *
Default value *
_Meas.v.
Lower limit value for measured value monitoring exceeded.
¯Meas.v.
Upper limit value for measured value monitoring exceeded.
_Dos.r.
Lower limit value for dosing rate monitoring exceeded.
¯Dos.r.
Upper limit value for dosing rate monitoring exceeded.
_Temp.
Lower limit value for temperature monitoring exceeded.
¯Temp.
Upper limit value for temperature monitoring exceeded.
*
Dosing stopped.
4.8.2 Curves - Measuring point list
Dialog window: Database ▶ Curves
With the context-sensitive menu item Measuring point list... in the curve
window the dialog window Measuring point list - 'Command
name.#' opens for showing the measuring point list for the selected curve.