Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 1397)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 7 Devices
tiamo 2.1 (ProcessLab) ￭￭￭￭￭￭￭￭ 1381
Connected devices
Information about the following peripheral devices connected to the MSB
connector appears here:
Dosing device 1
Dosing device type
Display of the dosing device type.
Dosing device serial number
Display of the serial number of the connected dosing device.
Stirrer 1
Stirrer type
Display of the stirrer type.
Stirrer serial number
Display of the serial number of the connected stirrer.
Remote box 1
Display of the connected remote box.
7.10.6 Properties - RS-232
Tab: Configuration ▶ Devices ▶ [Edit] ▶ Properties ▶ Properties - 'Device type' -
'Device name' ▶ RS-232
COM Port
Selection of the serial interface on the PC to which the device is connected.
Selection COM1 | COM2 | … | COMn
Default value COMn
COMn
First free COM port.
Baud rate
Transmission speed. Additionally, this baud rate must be set on the device
itself.
Selection 1200 | 2400 | 4800 | 9600
Default value 9600
[Connect]
Establishes a connection to the RS-232 device.
[Disconnect]
Disconnects the connection to the RS-232 device.