Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 1049)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.1 (ProcessLab) ￭￭￭￭￭￭￭￭ 1033
Identification Description
.CP{#}.MEA Measured wavelength of the calibration point in nm. If
no measured peak can be assigned, then not found
will be entered.
.CP{#}.REF Reference wavelength of the calibration point in nm.
.FIN Command status: 1 = Command has been ended
at least once, 0 = Command was started but not
ended, invalid = Command was not started (var-
iable not available).
.TOL Tolerance within which a measured peak can be
assigned to a calibration wavelength.
5.6.5.9.2 CAL Spec - General/Hardware
Tab: Method ▶ CAL Spec ▶ Properties... ▶ General/Hardware
Command name
Name of the command.
Input 25 characters
The general parameters for the device are defined on this tab.
Device
Device name
Selection of a device from those available in the device table. The only devi-
ces which shall be offered are those with which the command can run.
Selection 'Device name' | not defined
Default value not defined
not defined
In this case, the device name must be assigned by the user at the start of
the method.
Device type
Display or selection of the device type. If a device is selected under Device
name, then this Device type field can no longer be edited, and the device
type belonging to the selected device is displayed instead.
If the option not defined is selected as Device name, any device types or
device groups which are able to execute the command can be selected,
independently of the devices in the device table.
Selection Avantes Spectrometer
Default value Avantes Spectrometer