Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 758)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
742 ￭￭￭￭￭￭￭￭ tiamo 2.1 (ProcessLab)
5.6.3.5.2.6 KFT Ipol - Stop conditions
Tab: Method ▶ KFT Ipol ▶ Properties... ▶ Stop conditions
Command name
Name of the command.
Input 25 characters
Conditions for stopping the titration. If more than one stop condition is in
effect at the same time, then the criterion which is fulfilled first will stop the
titration.
Stop volume
Stops when the given volume has been added after the start of the titration
(including start conditions). The stop volume should be adapted to suit the
sample weight or the titration vessel size.
Titrando
Range
0.00000 ... 9999.99 mL
Default value 100,000 mL
Selection off
Titrino
Range
0.00 ... 9999.99 mL
Default value 100.00 mL
Selection off
Stop time
Stops when the preset time (including start conditions) has elapsed since the
start of the titration.
Titrando
Range
0 ... 999999 s
Selection off
Default value off
Filling rate
Rate at which the dosing cylinder is to be filled after titration. The maximum
filling rate depends on the cylinder volume of the exchange unit or dosing
device used.
Titrando
Range
0.01 ... 166.00 mL/min
Selection maximum
Default value maximum