Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 526)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
510 ￭￭￭￭￭￭￭￭ tiamo 2.1 (ProcessLab)
Time
Range
0.0 ... 999999.9 s
Volume
Range
0.00000 ... 9999.99 mL
5.6.3.2.5 DET Upol
5.6.3.2.5.1 DET Upol - Overview
Dialog window: Method ▶ DET Upol ▶ Properties... ▶ DET Upol - 'Command name'
Command for Dynamic Equivalence Point Titrations with amperomet-
ric measurement (selectable polarization voltage).
Devices
This command can be executed with the following devices.
Titrando: 808, 809, 835, 836, 857, 888, 904, 905, 906, 907
Titrino: 716, 721, 736, 751, 785, 794, 798, 799
Robotic Titrosampler: 855
Appearance
The command has the following appearance:
Parameters
The parameters for the command DET Upol are configured in the following
7 tabs:
￭ General/Hardware
Parameters for devices, dosing devices, sensors and stirrers.
￭ Start conditions
Parameters for the measurement of the initial measured value and for
defining the conditions which have to be met at the start of the titration.
￭ Titration parameters
Parameters for the run of the titration.
￭ Stop conditions
Definitions of conditions which cause the stop of the titration.
￭ Potentiometric evaluation
Parameters for the potentiometric evaluation of titration curves.
￭ Additional evaluations
Definition of additional methods for the evaluation of the titration curves.