Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 1459)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 7 Devices
tiamo 2.1 (ProcessLab) ￭￭￭￭￭￭￭￭ 1443
Action
Only active and editable for the Port type = Level detector.
If the fill level is too low and the level detector is therefore active, one of the
following actions will automatically be carried out at the start test:
Selection Record message | Display message | Stop deter-
mination
Default value Display message
Record message
The message that the level detector on the device is active will automat-
ically be saved in the determination.
Display message
A message is displayed and you can choose whether you want to con-
tinue the determination or cancel it. The determination is continued with
[Yes], with [No] it is canceled.
Stop determination
The running determination will be automatically canceled. The following
message must be confirmed with [OK].
7.19.5 Properties - Digital outputs
Tab: Configuration ▶ Devices ▶ [Edit]] ▶ Properties... ▶ Properties - 'Device type' -
'Device name' ▶ Digital outputs
On the tab Digital outputs all outputs detected are automatically listed.
The parameters for each digital output and the default values for the usage
in the program part Methods can be set.
Port
Display of the internal description of the port.
Port description
Display of the port description.
Type
Display of the port type.
Default value
Display of the default value the outputs takes directly after starting and exit-
ing the program. The default value is also set after an error or when canceling
the method.
Parameter 1
The meaning of Parameter 1 depends on the Type set.