Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 736)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
720 ￭￭￭￭￭￭￭￭ tiamo 2.1 (ProcessLab)
Titrino
Range
0.08 ... 16200 s
Default value 2.00 s
5.6.3.4.6.6 SET Upol - Stop conditions
Tab: Method ▶ SET Upol ▶ Properties... ▶ Stop conditions
Command name
Name of the command.
Input 25 characters
Conditions for stopping the titration. If more than one stop condition is in
effect at the same time, then the criterion which is fulfilled first will stop the
titration.
Stop volume
Stops when the given volume has been added after the start of the titration
(including start conditions). The stop volume should be adapted to suit the
sample weight or the titration vessel size.
Titrando, 855
Range
0.00000 ... 9999.99 mL
Default value 100,000 mL
Selection off
Titrino
Range
0.000 ... 9999.99 mL
Default value 100.00 mL
Selection off
Stop time
Stops when the preset time (including start conditions) has elapsed since the
start of the titration.
Titrando, 855
Range
0 ... 999999 s
Selection off
Default value off
Filling rate
Speed with which the dosing cylinder is to be refilled after the titration. The
maximum filling rate depends on the cylinder volume of the exchange unit
or dosing device used.