Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 249)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 4 Database
tiamo 2.1 (ProcessLab) ￭￭￭￭￭￭￭￭ 233
Selection DET | MET | SET | MEAS | MEAS T/Flow | MEAS
TC Cond | MEAS Ref | MEAS Opt | MEAS Spec |
CAL Spec | KFT | KFC | BRC | STAT | DOS
Default value DET
Command name
Name of the command for which the curve is to be produced. With not
defined all curves present in the determination with the selected Com-
mand type will be produced as default.
Note
In the command name, the index in the format .# must be specified addi-
tionally (e.g. Chloride.1).
Selection not defined | 50 characters
Default value not defined
Autoscaling
on | off (Default value: on)
If this option is switched on then all axes in the curve window will be scaled
automatically. In this case the fields Start value and End value cannot be
edited.
Tabs
Additional properties for the curve field can be set on the following 4 tabs:
￭ x axis
Parameters for the graphical display of the curve on the x axis.
￭ y1 axis
Parameters for the graphical display of the curve on the y1 axis (left-hand
y axis).
￭ y2 axis
Parameters for the graphical display of the curve on the y2 axis (right-
hand y axis).
￭ Options
Options for graphical display of curves.
4.4.1.4.3.13 Report template - Calibration curve field
Program window: Database ▶ Report template
Calibration curve fields are used for showing calibration or standard addition
curves in the report.