Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 542)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
526 ￭￭￭￭￭￭￭￭ tiamo 2.1 (ProcessLab)
Selection maximum
Default value maximum
5.6.3.2.5.6 DET Upol - Potentiometric evaluation
Tab: Method ▶ DET Upol ▶ Properties... ▶ Potentiometric evaluation
Command name
Name of the command.
Input 25 characters
Parameters for the potentiometric evaluation of the titration curve with
automatic equivalence point recognition. One of the following three evalu-
ation methods can be chosen here:
Potentiometric evaluation
Selection Evaluation without window | Evaluation with
measured value window (Upol) | Evaluation
with volume window (mL)
Default value Evaluation without window
Evaluation without window
With this option set, the two parameters EP criterion and EP recog-
nition will be applied across the entire range of the titration curve.
Evaluation with measured value window (Upol)
With this option set, up to 9 regions (windows) can be defined on the
measured value axis. Only those equivalence points which lie within these
windows and additionally meet the parameters defined for each window
will be recognized. Per window only one EP will be recognized. The
defined windows with their parameters are shown in the window table
and can be edited with the following buttons:
Evaluation with volume window (mL)
This option is visible only for Titrando and 855.. With this option up to
9 regions (windows) can be defined on the volume axis. Only those
equivalence points which lie within these windows and additionally meet
the parameters defined for each window will be recognized. Only one
EP will be recognized per window. The defined windows with their
parameters are shown in the window table and can be edited with the
following buttons:
Evaluation without window
EP criterion
Criterion for the recognition of equivalence points. Equivalence points
whose ERC is smaller than the set EP criterion will not be recognized.
Range 0 ... 200
Default value 5