Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 372)

4.8 Curves subwindow ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
356 ￭￭￭￭￭￭￭￭ tiamo 2.1 (ProcessLab)
Stop command (only Titrando)
The running STAT command was quit, then the next command was
started.
Wait for [Continue]
Reagent dosing in the current STAT command was interrupted until it
was continued by a manual command.
Wait for limit ok
Reagent dosing in the current STAT command was interrupted until the
monitored measured value was again within the limits (including hyste-
resis). Afterwards reagent dosing was resumed automatically.
none
No action was taken.
4.8.4 Properties
4.8.4.1 Curve properties - Overview
Dialog window: Database ▶ Curves ▶ Properties curves #
The properties for the display of curves can be set on the following 5 tabs:
￭ x axis
Parameters for the graphical display of the curves on the x axis.
￭ y1 axis
Parameters for the graphical display of the curves on the y1 axis (left-
hand y axis).
￭ y2 axis
Parameters for the graphical display of the curves on the y2 axis (right-
hand y axis).
￭ Options
Options for graphical display of curves.
￭ Measuring point list
Parameters for showing the measuring point list.
4.8.4.2 Curve properties - x axis
Dialog window: Database ▶ Curves ▶ Properties curves # ▶ x axis
Parameters for the graphical display of the curves on the x axis.
Command type
Selection of the command type for which the curve properties are to be
defined. The curve properties defined for each command type are saved per
curve window and per client.
Selection DET | MET | SET | MEAS | MEAS T/Flow | MEAS
TC Cond | MEAS Ref | MEAS Opt | MEAS Spec |
CAL Spec | KFT | KFC | BRC | STAT | DOS
Default value DET