Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 1483)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 8 Manual Control
tiamo 2.1 (ProcessLab) ￭￭￭￭￭￭￭￭ 1467
8.3 Manual Control - Device selection
Program part: Manual Control
In the subwindow for the device selection, the devices or function units of
devices can be selected, on which the functions are to be triggered manually.
Therefore they are displayed in tree-form. Displayed are all devices config-
ured in the device table with status "ok", device name and (in brackets) the
device type number. The currently selected device is shown with a blue
background. Devices, which are still running manually triggered actions, are
shown with red lettering.
8.4 Manual Control - Functions
Program part: Manual Control
In the subwindow Functions/Parameters, the functions for the manual con-
trol of the selected device and the accompanying parameters can be selec-
ted. In addition, here the measured values for running actions and messages
are displayed.
Depending on the device different functions are possible.
8.4.1 Dosing
8.4.1.1 Dosing - Overview
Program part: Manual Control
If in the subwindow for the device selection, the group Dosing device or
a single Dosing device is selected, then the functions and parameters
belonging to these dosing devices are displayed in the subwindow Func-
tions/Parameters.
Dosing functions
The dosing functions for exchange and dosing units are displayed on the
following tabs:
￭ General
￭ Prepare
￭ Fill
￭ Empty
￭ Fixed volume
￭ Dosing
Devices
The dosing functions can be carried out with dosing devices that are built in
or connected to the following devices: