Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 257)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 4 Database
tiamo 2.1 (ProcessLab) ￭￭￭￭￭￭￭￭ 241
Scaling
Start value
Initial value for scaling the x axis.
Range -1.0 E12 ... 1.0 E12
Default value 0.0
End value
End value for scaling the x axis.
Range -1.0 E12 ... 1.0 E12
Default value 1000.0
4.4.3.2.3 Curve overlay - y axis
Dialog window: Database ▶ Tools ▶ Templates ▶ Curve overlay templates ▶ Prop-
erties
Parameters for the graphical display of the overlaid curves on the y axis.
y axis
Size
Selection of the quantiy to be shown on the y axis.
Selection Command-dependent selection
Label
Freely definable axis label for the y axis. With auto the designation from the
field Size will be used.
Input 25 characters
Default value auto
Display measuring points
on | off (Default value: on)
If this check box is activated then the individual measuring points will be
shown on the curve.
Note
With curves, for which the distance between to measuring points is
smaller than 5 pixels, the separate measuring points are not displayed
anymore, even if a symbol has been selected. In this case, the graphics
window can eventually be enlarged in order to display the symbols again.