Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 1244)

6.3 Configuration data ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1228 ￭￭￭￭￭￭￭￭ tiamo 2.1 (ProcessLab)
Input 1000 characters
Measured observational pairs
Table with the value pairs for Temperature and Conductivity, which were
determined for the conductivity standard. The table cannot be edited, but
with a click on the column title the temperature can be sorted according to
either increasing or decreasing sequence.
[New]
Creation of a new value pair. The window Edit value pair opens, in which
a new value pair can be entered (see Chapter 6.3.3.4.3, page 1228).
[Edit]
Edits the selected value pair. The window Edit value pair opens, in which
the value pair can be edited (see Chapter 6.3.3.4.3, page 1228).
[Delete]
Deletes the selected value pair.
6.3.3.4.3 Edit observational pair
Dialog window: Configuration ▶ Tools ▶ Templates ▶ Conductivity stand-
ards ▶ Conductivity standards ▶ Edit conductivity standard ▶ Edit observational
pair
With [New] or [Edit] in the Edit conductivity standards dialog window,
the dialog window Edit value pair opens for entering a new value pair or
for editing an existing value pair.
Temperature
Temperature at which the conductivity was determined.
Range -20 ... 150 °C
Conductivity
Conductivity for the specified temperature (6 significant places).
Range 0.00000 ... 2000.00 mS/cm
6.3.3.5 E-mail templates
6.3.3.5.1 Manage E-mail templates
Dialog window: Configuration ▶ Tools ▶ Templates ▶ E-mail templates... ▶ E-mail
templates
The stored E-mail templates are displayed in a table in the dialog window
E-mail templates. The table cannot be edited, but with a click on the col-
umn title the table can be sorted according to the selected column in either
increasing or decreasing sequence.