Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 1540)

9.3 Determinations ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1524 ￭￭￭￭￭￭￭￭ tiamo 2.1 (ProcessLab)
Note
In order to calculate statistical calculations for results, the Statis-
tics option must be enabled in the START command of the method
and, in addition, the Statistics option must be enabled in the
CALC command for each desired result.
5 Activate the Statistics check box.
6 If desired, modify number of single determinations.
7 Enter sample data.
8 Click on [Start].
The single determination will be started. The subwindow Method
shows active tracks and commands, the subwindow Live display live
curves, measured values and messages.
Note
If the method contains a DATABASE command, then it is manda-
tory that this command be executed in all statistically linked deter-
minations. If this is not done, then the statistical results will be
displayed incorrectly and the determinations cannot be reprocessed.
9.3.2 Starting determination series
How to proceed?
Determination series without statistics
1 Select program part Workplace.
2 Use the Run subwindow to select the Determination series tab.
3 If desired, enter Determination parameters.
4 Load existing sample table or enter sample data directly into the work-
ing sample table.
The subwindow Method shows the method loaded in the first line.