Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 1420)

7.13 864 Balance Sample Processor ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1404 ￭￭￭￭￭￭￭￭ tiamo 2.1 (ProcessLab)
Rinse position
Rinse position valid for all 4 external positions.
Range 0 ... 235 mm
Default value 0 mm
[Configuration]
Opens the dialog window Configuration (see Chapter 7.11.7, page
1391) in which the properties of the robotic arm can be editet.
Table for external positions
The properties for the 4 possible external positions for the swing head
mounted on the tower are shown in the table. The table is not editable
directly.
External position
Number of the external position.
Angle [°]
Swing angle for external position.
Work position [mm]
Work position for external position.
[Edit]
Opens the dialog window External position # (see Chapter 7.11.8, page
1392) in which the parameters for the external position selected from the
table can be edited.
7.13.4 Properties - Rack
Tab: Configuration ▶ Device ▶ [Edit] ▶ Properties... ▶ Properties - 'Device type' -
'Device name' ▶ Rack
On the tab Rack the rack-specific data of the attached rack are shown.
Rack name
Shows the name of the rack attached. If no rack is in position then "-----" is
shown.
Rack code
Shows the rack code of the rack attached. The rack code corresponds to the
arrangement of magnets on the base of the rack and is read in by the Sample
Processor in order to recognize the rack. If no rack is in position then the
display will be empty.