Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 1162)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1146 ￭￭￭￭￭￭￭￭ tiamo 2.1 (ProcessLab)
Parameters
The parameters for the command WEIGH are configured in the following
dialog window:
￭ WEIGH - Properties
Command variables
The following command variables are generated in the method run by the
command WEIGH and can be used in formulas under the designation
'Command name.Variable designation':
Identifi-
cation Description
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command has
not ever been started
.FIN Command status; 1 = Command has been ended at
least once, 0, invalid (variable not available) = Command
has never been ended
.TOU Timeout status: 1 = Max. waiting time expired; 0 =
Max. waiting time not expired
5.6.9.7.2 WEIGH - Properties
Dialog window: Method ▶ WEIGH ▶ Properties... ▶ WEIGH - 'Command name'
Command name
Name of the command.
Input 25 characters
Device
Device name
Selection of a device from those available in the device table. The only devi-
ces which shall be offered are those with which the command can run.
Selection 'Device name' | not defined
Default value not defined
not defined
In this case, the device name must be assigned by the user at the start of
the method.