Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 1003)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.1 (ProcessLab) ￭￭￭￭￭￭￭￭ 987
Identifi-
cation Description
.ENP Electrode zero point calculated from the calibration
.ETE End temperature (temperature following processing of the
command) in °C
.FIN Command status; 1 = Command has been ended at
least once, 0, invalid (variable not available) = Com-
mand has never been ended
.IME Initial measured value (measured value before start condi-
tions are processed) in the unit of the measured value
.ITE Initial temperature (temperature before start conditions are
processed) in °C
.MTE Temperature measurement with sensor; 1 = on, 0 = off)
.RES Calculated result of the standard addition in the selected
unit
.SLO Electrode slope calculated from the calibration
.STY Type of stop with which the command was stopped: 1 =
normal;0 = manual or after error
.TITER Titer value of the solution used for the command
.VAR Variance of the calculated result of the standard addition in
the selected unit
.VOL Dosed volume
5.6.4.16.2 STDADD auto - General/Hardware
Tab: Method ▶ STDADD auto ▶ Properties... ▶ General/Hardware
Command name
Name of the command.
Input 25 characters
The general parameters for the control device, the dosing device, the sensor
and the stirrer are defined on this tab.
Device
Device name
Selection of a device from those available in the device table. The only devi-
ces which shall be offered are those with which the command can run.
Selection 'Device name' | not defined
Default value not defined