Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 462)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
446 ￭￭￭￭￭￭￭￭ tiamo 2.1 (ProcessLab)
Titrando, 855
Range
0.01000 ... 9999.99 mL
Selection off
Default value off
Stop time
Stops when the preset time (including start conditions) has elapsed since the
start of the titration.
Titrando, 855
Range
0 ... 999999 s
Selection off
Default value off
Filling rate
Speed with which the dosing cylinder is to be refilled after the titration. The
maximum filling rate depends on the cylinder volume of the exchange unit
or dosing device used.
Titrando, 855
Range
0.01 ... 166.00 mL/min
Selection maximum
Default value maximum
Titrino
Range
0.01 ... 150.00 mL/min
Selection maximum
Default value maximum
5.6.3.2.2.6 DET pH - Potentiometric evaluation
Tab: Method ▶ DET pH ▶ Properties... ▶ Potentiometric evaluations
Command name
Name of the command.
Input 25 characters
Parameters for the potentiometric evaluation of the titration curve with
automatic equivalence point recognition. One of the following evaluation
methods can be chosen:
Potentiometric evaluation
Selection Evaluation without window | Evaluation with
measured value window (pH) | Evaluation with
volume window (mL)
Default value Evaluation without window