Metrohm tiamo 2.1 (ProcessLab) - Manual (Page 134)

3.6 Subwindow Run ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
118 ￭￭￭￭￭￭￭￭ tiamo 2.1 (ProcessLab)
Run test error
This display appears if an error has occurred during the run test. During
a determination series, the user can determine, on the basis of the line
number displayed, the line to which the the error message belongs that
appeared at the time of the error and that is currently displayed in the
usual message window.
Run test finished without errors
This display appears at the end of a run test that has been completed
without errors.
3.6.3 Single determination
3.6.3.1 Single determination - Overview
Tab: Workplace ▶ Run ▶ Single determination
Parameters and sample data for single determinations can be edited and run
functions can be triggered on the tab Single determination. It contains
the following tools and functions:
￭ Single determination - Operating elements
Buttons for starting, stopping, interrupting and resuming determinations.
￭ Single determination - Status display
Shows the current status of the workplace.
￭ Single determination - Determination parameters
Enters general parameters for the determination.
￭ Single determination - Sample data
Entry of method and sample identification for the next determination.
￭ Properties - Overview
Definition of the properties for the tab Single determination.
3.6.3.2 Single determination - Operating elements
Tab: Workplace ▶ Run ▶ Single determination
The following operating elements are located on the tab Single determi-
nation:
Start single determinations (Abbreviation: Ctrl G)
The button is present in the status READY (no determination started),
COND READY (condition requirement fulfilled) and COND BUSY (condi-
tioning is running). If the start can be triggered, then it will be green,
otherwise light gray. Conditioning will be started first for methods that have
conditioning.
Stop single determination (Abbreviation: Ctrl S)