H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 153)

137
Item Description
Member
Type
Untagged
Select the Untagged, Tagged, or Not a Member option:
• Untagged—Indicates that the port sends the traffic of the VLAN with the VLAN
tag removed.
• Tagged—Indicates that the port sends the traffic of the VLAN without removing
the VLAN tag.
• Not a Member—Removes the port from the VLAN.
IMPORTANT:
• You cannot configure an access port as an untagged member of a nonexistent
VLAN.
• When you configure an access port as a tagged member of a VLAN, or
configure a trunk port as an untagged member of multiple VLANs in bulk, the link
type of the port is automatically changed into hybrid.
• You can configure a hybrid port as a tagged or untagged member of a VLAN
only if the VLAN is an existing, static VLAN.
Tagged
Not a
Member
VLAN ID Specify the VLAN to which the port belongs.
VLAN configuration examples
Network requirements
As shown in Figure 115 :
• GigabitEthernet 1/0/1 of AC is connected to GigabitEthernet 1/0/1 of Switch.
• GigabitEthernet 1/0/1 on both devices are hybrid ports with VLAN 100 as their default VLAN.
• Configure GigabitEthernet 1/0/1 to permit packets of VLAN 2, VLAN 6 through VLAN 50, and
VLAN 100 to pass through.
Figure 115 Network diagram
Configuring AC
1. Create VLAN 2, VLAN 6 through VLAN 50, and VLAN 100:
a. Select Network > VLAN from the navigation tree to enter the VLAN tab.
b. Click Add.
c. Enter VLAN IDs 2,6-50,100, as shown in Figure 116 .
d. Click Apply.