H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 280)

264
Figure 260 Creating a wireless service
3. Configure wireless service.
After you create a wireless service, you will enter the wireless service configuration page.
a. In the Security Setup area, select Open-System from the Authentication Type list.
b. Select the Cipher Suite box, select ASE-CCMP and TKIP (select an encryption type as needed),
and then select WPA from the Security IE list.
c. Select the Port Set box, and select psk from the Port Mode list.
d. Select pass-phrase from the Pre-shared Key list, and enter the key ID 12345678.
e. Click Apply.
Figure 261 Security setup
4. Enable wireless service.
a. Select Wireless Service > Access Service from the navigation tree.
b. Select the psk[Bind] box.
c. Click Enable.