Verifying the configuration – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 616
600
Figure 637 Configuring traffic load balancing
3.
Configure a load balancing group:
a.
Select Advanced > Load Balance from the navigation tree.
b.
Click the Load Balance Group tab to enter the load balancing group configuration page.
c.
Click Add.
d.
On the page that appears, select ap1. radio 2 and ap2. radio 2 in the Radios Available area,
click << to add them into the Radios Selected area, and click Apply.
Figure 638 Configuring a load balancing group
Verifying the configuration
•
Radio 2 of AP 1 and radio 2 of AP 2 are in the same load balancing group, and the radio of AP
3 does not belong to any load balancing group. Because load balancing takes effect on only
radios in a load balancing group, AP 3 does not take part in load balancing.