H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 91
75
Figure 52 Network time
3.
Configure system time parameters as described in
.
4.
Click Apply.
Table 33 Configuration items
Item Description
Clock status
Display the synchronization status of the system clock.
Local Reference Source
Set the IP address of the local clock source to 127.127.1.u, where u
ranges from 0 to 3, representing the NTP process ID.
•
If the IP address of the local clock source is specified, the local clock
is used as the reference clock, and thus can provide time for other
devices.
•
If the IP address of the local clock source is not specified, the local
clock is not used as the reference clock.
Stratum
Set the stratum level of the local clock.
The stratum level of the local clock decides the precision of the local
clock. A higher value indicates a lower precision. A stratum 1 clock has
the highest precision, and a stratum 16 clock is not synchronized and
cannot be used as a reference clock.
Source Interface
Set the source interface for an NTP message.
If you do not want the IP address of a certain interface on the local
device to become the destination address of response messages, you
can specify the source interface for NTP messages, so that the source IP
address in the NTP messages is the primary IP address of this interface.
If the specified source interface is down, the source IP address of the
NTP messages sent is the primary IP address of the outbound interface.