H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 595)

579
Table 202 Configuration items
Item Remarks
Group ID Display the ID of the load balancing group
Description
Configure a description for the load balancing group.
By default, the load balancing group has no description.
Radio List
• In the Radios Available area, select the target radios, and then click << to add them into
the Radios Selected area.
• In the Radios Selected area, select the radios to be removed, and then click >> to remove
them from the load balancing group.
Configuring parameters that affect load balancing
1. Select Advanced > Load Balance from the navigation tree. See Figure 609 .
2. Configure parameters that affect load balancing as described in Table 203 .
3. Click Apply.
Table 203 Configuration items
Item Remarks
Max Denial Count
Maximum denial count of client association requests.
If a client has been denied more than the specified maximum times, the AP
considers that the client is unable to associate to any other AP and accepts the
association request from the client.
RSSI Threshold
Load balancing RSSI threshold.
A client may be detected by multiple APs. An AP considers a client whose RSSI
is lower than the load balancing RSSI threshold as not detected. If only one AP
can detect the client, the AP increases the access probability for the client even
if it is over-loaded.
Configuring AP
Upgrading AP version
1. Select Advanced > AP from the navigation tree.
2. On the AP Module tab, select the desired AP.
3. Click Version Update to enter the page for AP version upgrade.
Figure 612 AP version update
4. Configure AP upgrade as described in Table 204 .