H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 592)

576
Configuring load balancing
Band navigation and load balancing can be used simultaneously.
Configuration prerequisites
Before you configure load balancing, make sure:
• The target APs are associated with the same AC.
• The clients can find the APs.
• The fast association function is disabled. By default, the fast association function is disabled. For
more information about fast association, see "Configuring access services."
Recommended configuration procedure
Task Remarks
1. Configuring a load balancing mode Required.
2. Configuring AP-based load balancing Required.
Use either approach.
• AP-based load balancing—After you complete Configuring a
load balancing mode , the AC adopts AP-based load
balancing by default.
• Group-based load balancing—H3C recommends that you
complete Configuring a load balancing mode first. A load
balancing group takes effect only when a load balancing
mode is configured.
3. Configuring group-based load
balancing
4. Configuring parameters that affect
load balancing
Optional.
This configuration takes effect for both AP-based load balancing
and radio group based load balancing.
Configuring a load balancing mode
NOTE:
If the AC has a load balancing mode configured but has no load balancing group created, it uses
AP-based load balancing by default.
1. Configure session-mode load balancing
a. Select Advanced > Load Balance from the navigation tree to enter the page for setting load
balancing.
b. Select Session from the Loadbalance Mode list.
c. Click Apply.