H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 553)

537
data transmission. When the specified idle duration of the channel times out, APs or clients randomly
select a backoff slot within the contention window to perform backoff. The device that finishes backoff first
gets the channel. With 802.11, all devices have the same idle duration and contention window. They are
equal when contending for a channel. In WMM, this fair contention mechanism is changed.
EDCA parameters
WMM assigns data packets to four access categories. By allowing a high-priority access category to
have more channel contention opportunities than a low-priority access category, WMM offers different
service levels to access categories.
WMM define a set of EDCA parameters for each access category, covering the following:
• Arbitration inter-frame spacing number (AIFSN)—Different from the 802.11 protocol where the idle
duration (set using DIFS) is a constant value, WMM can define an idle duration per access category.
The idle duration increases as the AIFSN value increases (see Figure 564 for the AIFS durations).
• Exponent of CWmin (ECWmin) and exponent of CWmax (ECWmax)—Determine the average
backoff slots, which increases as the two values increase (see Figure 564 for the backoff slots).
• Transmission opportunity limit (TXOPLimit)—Indicates the maximum time for which a user can hold
a channel after a successful contention. The greater the TXOPLimit is, the longer the user can hold
the channel. The value 0 indicates that the user can send only one packet each time it holds the
channel.
Figure 564 Per-AC channel contention parameters in WMM
CAC admission policies
CAC requires that a client obtain permission of the AP before it can use a high-priority access category
for transmission, and guarantees bandwidth to the clients that have gained access. CAC controls real
time traffic (AC-VO and AC-VI traffic) but not common data traffic (AC-BE and AC-BK traffic).
To use a high-priority access category, a client must send a request to the AP. The AP returns a positive
or negative response based on either of the following admission control policy:
• Channel utilization-based admission policy—The AP calculates the total time that the existing
high-priority access categories occupy the channel in one second, and then calculates the time that
the requesting traffic will occupy the channel in one second. If the sum of the two values is smaller