H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 20)

4
Feature matrixes
In this document, Yes means a feature is supported, and No means not supported.
Feature matrix for the WX5000 series
NOTE:
The LSWM1WCM10 and LSWM1WCM20 access controller modules of the WX5000 series adopt the OAP architecture. They work as OAP cards to
exchange data and status and control information with the switch through their internal interfaces. Do not configure services such as QoS rate limiting and
802.1X authentication on XGE 1/0/1 of the LSWM1WCM10, and the logical aggregate interface BAGG1 formed by GE 1/0/1 and GE 1/0/2 of the
LSWM1WCM20.
Table 2 Feature matrix for the WX5000 series
Module Feature WX5002V2 WX5004 LSWM1WCM10 LSWM1WCM20
Device
License management
Supports 32 concurrent
APs by default, and can
be extended to support
64 concurrent APs.
Supports 64 concurrent
APs by default, and can
be extended to support
256 concurrent APs.
Supports 64 concurrent
APs by default, and can
be extended to support
256 concurrent APs.
Supports 32 concurrent
APs by default, and can
be extended to support
128 concurrent APs.
File management CF Yes CF Yes CF Yes Flash Yes
Port mirroring Yes Yes No No
Loopback test Yes on GE interfaces Yes on GE interfaces
Internal loopback testing
Yes on XGE interfaces
only
Internal loopback testing
Yes on GE interfaces
only
Network IGMP Snooping
The maximum number of
multicast groups ranges
from 1 to 256 and
defaults to 256.
The maximum number of
multicast groups ranges
from 1 to 256 and
defaults to 256.
The maximum number of
multicast groups ranges
from 1 to 256 and
defaults to 256.
The maximum number of
multicast groups ranges
from 1 to 256 and
defaults to 256.