H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 570)

554
3. Click Add in the Service-Based Configuration area to enter the page for configuring wireless
service-based rate limit settings for clients, as shown in Figure 584 .
4. Configure static rate limiting:
a. Select service1 from the Wireless Service list.
b. Select Inbound from the Direction list.
c. Select Static from the Mode list.
d. Enter 128 in the Per-Client Rate field.
5. Click Apply.
Figure 584 Configuring static rate limiting
Verifying the configuration
1. Client1 and Client2 access the WLAN through the SSID named service1.
2. Check that traffic from Client1 is rate limited to around 128 kbps, so is traffic from Client2.
Wireless service-based dynamic rate limiting
configuration example
Network requirements
As shown in Figure 585 , wireless clients access the WLAN through a SSID named service2.
Configure all wireless clients to share 8000 kbps of bandwidth in any direction.
Figure 585 Network diagram