H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 541)

525
Table 179 Configuration items
Item Remarks
Wlan Service Display the specified WLAN service to which you want to apply a QoS policy.
Inbound Policy Apply the QoS policy to the packets received by the wireless service.
Outbound Policy Apply the QoS policy to the packets sent by the wireless service.
Trust Mode
Set the priority trust mode:
• Untrust—Trusts the port priority.
• Dscp—Uses the DSCP values of received packets for mapping.
• 802.11e—Uses the 802.11e priority of received 802.11 packets for mapping.
QoS Priority Set the local precedence value.
ACL and QoS configuration example
Network requirements
As shown in Figure 553 , in the WLAN, the FTP server (10.1.1.1/24) is connected to the AC (SSID:
service1), and the wireless clients are connected to the AC through APs and a Layer 2 switch and access
the network resources.
Configure an ACL and a QoS policy on the AC to prohibit the wireless clients from accessing the FTP
server from 8:00 to 18:00 every day:
1. Add an ACL to prohibit the hosts from accessing the FTP server from 8:00 to 18:00 every day.
2. Configure a QoS policy to drop the packets matching the ACL.
3. Apply the QoS policy in the inbound direction of the wireless service named service1.
Figure 553 Network diagram
Configuration procedure
NOTE:
Before performing the following configurations, make sure the AC has been configured with wireless
service service1. For more information about the wireless service configuration, see "Configuring access
services."
1. Define a time range to cover the time range from 8:00 to 18:00 every day:
FTP server
10.1.1.1/24
AC L2 switch
AP 1
AP 2
Client 1
Client 2