H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 594)

578
Table 201 Configuration items
Item Description
Loadbalance Mode
Select Traffic.
The function is disabled by default.
Traffic
Load balancing is carried out for a radio when the traffic threshold
and traffic gap threshold are reached.
Gap
Load balancing is carried out for a radio when the traffic threshold
and traffic gap threshold (the traffic gap between the two APs) are
reached.
NOTE:
If you select the traffic-mode load balancing, the maximum throughput of 802.11g/802.11a is 30 Mbps.
Configuring group-based load balancing
NOTE:
H3C recommends you to complete Configuring a load balancing mode on the Load Balance tab page.
A load balancing group takes effect only when a load balancing mode is configured.
1. Select Advanced > Load Balance from the navigation tree.
2. Click the Load Balance Group tab to enter the page for configuring a load balancing group.
3. Click Add.
Figure 611 Configuring a load balancing group
4. Configure a load balancing group as described in Table 202 .
5. Click Apply.