Freescale Semiconductor Microcontrollers - Manual (Page 164)

Control Points
Setting Breakpoints
164 Microcontrollers Debugger Manual
NOTE For more information about this syntax, see BS and SAVEBP commands.
Setting Breakpoints
Breakpoints may be set in a Source or Assembly component window.
Positions Where a Breakpoint Is Definable
A compound statement is one that can be split into several base instructions. When using a
high level language some compound statements can be generated, as shown in the
following example.
Figure 4.3 Source and Assembly Windows
The debugger helps you detect all positions where you can set a breakpoint.
1. Right-click in the Source component. The Source Context Menu is displayed on the
screen.
2. Choose Marks from the Context Menu. All statements where a breakpoint can be set
are identified by a special red inverted check mark:
To remove the breakpoint marks, right-click in the Source component and choose Marks
again.