Freescale Semiconductor Microcontrollers - Manual (Page 710)

Flash Programming
NVMC Commands
710 Microcontrollers Debugger Manual
NVMC Commands
The following Flash commands can be issued through the debugger Command component
window, as shown in the figure below.
Figure 32.10 NVMC Commands In Command Window
FLASH
Short Description
Displays Flash modules, loads .fpp file, or performs Flash operations.
Syntax
FLASH [(SELECT|UNSELECT|ERASE|ENABLE|DISABLE|PROTECT|
UNPROTECT|AEFSKIPERASING) [<blockNo>]]
|[ARM|DISARM|SAVECONTEXT|LOADCONTEXT|MEMMAP|MEMUNMAP|RELEASE
|OVLBACKUP|OVLRESTORE|PROTOCOLON|PROTOCOLOFF|SKIPSTATUS
ON|SKIPSTATUSOFF|NOUNSECURE|UNSECURE]
|[NVMFREQUENCY <frequency in Hz>]
|[NVMIF2RELOCATE <address>]
|[NVMIF2WORKSPACE <address> <address>]
|[INIT <fileName> | AUTOID]
Description
The FLASH command displays names, locations, and states of all available modules;
provided that a parameter (.fpp) file is already loaded. If no parameter file is loaded, this
command loads either the .fpp file for the current MCUID or the last-used .fpp file.