Freescale Semiconductor Microcontrollers - Manual (Page 671)

ColdFire P&E Multilink/Cyclone Pro Connection
First Steps From Within an Existing Project
671 Microcontrollers Debugger Manual
First Steps From Within an Existing Project
To take the first steps toward debugging with the CodeWarrior IDE and setting the P&E
Multilink/Cyclone Pro connection from within an existing debugging project:
1. Run the CodeWarrior IDE with the shortcut created in the program group.
2. Open the project.
3. Choose Project > Debug to start the debugger.
4. In the debugger choose Component > Set Connection to select another target interface
in the Set Connection dialog box.
5. Select ColdFire as the Processor then P&E Multilink/Cyclone Pro as the connection.
Figure 29.2 Set Connection Dialog Box - P&E Multilink/Cyclone Pro Selection
6. Press the OK button - Set Derivative dialog box opens.
7. In the Set Derivative dialog box, choose the correct target processor.