Freescale Semiconductor Microcontrollers - Manual (Page 767)

Debugger Engine Commands
Debugger Commands
767 Microcontrollers Debugger Manual
CMDFILE
The CMDFILE command allows you to define all target specific commands in a
command file. For example, startup, preload, reset, and path of this file.
Usage
CMDFILE <Command File Kind> ON|OFF ["<Command File Full
Name>"]
Components
Simulator/target engine.
Example:
in>cmdfile postload on "c:\temp\myposloadfile.cmd"
The myposloadfile command file executes after loading the absolute file.
CR
The CR command initiates writing records of commands to an external file. Writing
records continues until a close record file (
NOCR ) command is executed.
NOTE Drag & drop actions are also translated into commands in the record file.
NOTE If no path is specified, the destination directory is the current project directory.
Usage
CR [fileName][;A]
If fileName is not specified, a standard Open File dialog box is opened.
;A specifies to open a file fileName in append mode. Records are appended at the
end of an existing record file.
If the ;A option is omitted and fileName is an existing file, the file is cleared before
records are written to it.
Components
Debugger engine.