Freescale Semiconductor Microcontrollers - Manual (Page 472)

HCS08 P&E Multilink/Cyclone Pro Connection
Connection Procedure
472 Microcontrollers Debugger Manual
Figure 19.7 Advanced Options Dialog Box
Prompt on Flash Program Checkbox
Checking Always Erase and Program Flash without asking in this dialog box lets the
software transparently program the microprocessor.
Trim Options
The Calculate Trim and Program the Non-Volatile Trim Register checkbox enables
automatic calculation and programming of the trim value in a designated Non-Volatile
memory location.
Non-Volatile Memory Preservation
The user is given the option of preserving up to three independent ranges of non-volatile
memory (on devices with EEPROM, the entire EEPROM array may optionally be
preserved as well). Ranges that are designated as “preserved” are read before an erase, and
re-programmed immediately afterwards, thereby preserving the data in these ranges. Any
attempts to program data into a preserved range is ignored.
When entering an address into the preserved range field (hexadecimal input is expected),
the values are masked according to the row size of the device. This ensures that the
reprogramming of preserved data does not cause any program disturb conditions.
Sync to PLL Change Checkbox
Sync to PLL Change is required for the software/hardware connection to synchronize
with the microprocessor during the Flash erasing/programming procedure. This option is
always enabled for M68HCS08 devices.