Freescale Semiconductor Microcontrollers - Manual (Page 445)

HCS08 Full Chip Simulation
Peripheral Modules Commands
445 Microcontrollers Debugger Manual
the same time, you can use the INPUTS command to bring up the Simulated Port Inputs
for all general I/O ports. It displays the current simulated values to all applicable input
ports. See the
Input/Output Ports User Commands and Input/Output Ports User
Commands for more information about the various forms of this command.
Figure 18.16 Simulated Port Inputs Dialog Box
Use the Simulated Port Inputs dialog box to reconfigure the input value to any I/O port.
Use the INPUTS command to reconfigure the output values on any relevant I/O port. You
can observe the manipulation of I/O port pins in the Memory Window.
Figure 18.17 Memory Component Window
Note that if the regular I/O pins are multiplexed to be used by a different MCU Module,
they might not be available for general I/O functionality. For more information on how to
properly configure I/O pins, refer to the Freescale user manual for your microprocessor.
Input/Output Ports User Commands
The following user commands are available for accessing the M68HCS08 I/O ports.