Freescale Semiconductor Microcontrollers - Manual (Page 378)

HC08 P&E Multilink/Cyclone Pro Connection
Connection Procedure
378 Microcontrollers Debugger Manual
View Register Files Option
The View Register Files menu selection also gives the user the option of running the
register file viewer/editor. If register files are available for the device that you have
chosen, the Choose a Register Block window (see
Figure 14.17 ) opens. You may also
open it by entering the R command in the Command Window command line.
Figure 14.17 Choose A Register Block Window
If register files have been installed on the host computer, selecting a block brings up the
Register Block register listing (see
Figure 14.18 ), which shows a list of the associated
registers, their addresses, and their descriptions. This begins interactive setup of system
registers such as I/O, timer, and COP watchdog.
Figure 14.18 Register Block Register Listing
Selecting a file brings up the Register Window (see Figure 14.19 ), which displays the
values and significance for each bit in the register. The registers can be viewed and their
values modified, and the values can be stored back into debugger memory.
Figure 14.19 Register Window