Freescale Semiconductor Microcontrollers - Manual (Page 567)

567 Microcontrollers Debugger Manual
27
SofTec RS08 Connection
This section guides you through the first steps toward debugging with the CodeWarrior
IDE and the SofTec RS08 connection.
SofTec RS08 Technical Considerations
The 8/16 bit debugger (and then the CodeWarrior IDE) might be connected to RS08
hardware using the SofTec RS08.
When the debugger runs the SofTec RS08 connection, it can communicate and debug
RS08 core based hardware connected through the SofTec in-circuit debugger/programmer
units, such as:
SofTec Microsystems HCS08 ISP Debuggers/Programmers (inDART Series) and Starter
Kits (PK and newer Series).
Refer to the inDART®-HCS08 In-Circuit Debugger/Programmer for Motorola HCS08
Family FLASH Devices User’s Manual from SofTec for communication hardware
requirements and SofTec product installation.
CodeWarrior IDE and SofTec RS08
Connection
There are two separate paths that may be followed to take the first steps toward debugging
with the CodeWarrior IDE and the SofTec inDART-RS08 connection. The differences
between the two paths hinge on the starting point for the steps:
• Using the Stationary Wizard at the start of the project
• From within an existing project