Freescale Semiconductor Microcontrollers - Manual (Page 376)

HC08 P&E Multilink/Cyclone Pro Connection
Connection Procedure
376 Microcontrollers Debugger Manual
Advanced Programming/Debug Options
The Advanced Programming/Debug Options menu entry opens the Advanced Options
dialog box, where you can configure software settings for the FLASH programming
procedure.
Figure 14.15 Advanced Options Dialog Box
Prompt on Flash Program Checkbox
Checking Always Erase and Program Flash without asking lets the software
transparently program the microprocessor.
Trim Options
The Calculate Trim and Program the Non-Volatile Trim Register checkbox enables
automatic calculation and programming of the trim value in a designated Non-Volatile
memory location.
Sync to PLL Change Checkbox
Sync to PLL Change is required for the software/hardware connection to synchronize
with the microprocessor during the Flash erasing/programming procedure.