Freescale Semiconductor Microcontrollers - Manual (Page 452)

HCS08 Full Chip Simulation
Peripheral Modules Commands
452 Microcontrollers Debugger Manual
Figure 18.24 Simulated Port Inputs Dialog Box
When using In-Circuit Simulation mode, the INPUTS command shows the simulated
input values to any applicable port.
Syntax
>INPUTS
Example
>INPUTS
Show I/O port input values.
Modulo Timer Interrupt Module
In FCS, this module simulates all functionality of the Modulo Timer Interrupt (MTIM)
Module, including:
• programmable MTIM clock input
• free running or modulo up count operation
• flag polling
• interrupt enabled mode of operation
Once the MTIM Status and Control register properly configures the operation of the
module, the MTIM Counter starts incrementing. If modulo up count operation is enabled,
you can observe the MTIM overflow flag in the MTIM Status and Control register in the
Memory Window.