Freescale Semiconductor Microcontrollers - Manual (Page 404)

HC08 FSICEBASE Emulator
FSICEBASE Overview
404 Microcontrollers Debugger Manual
clock, an oscillator, or any other circuitry that you might use to perform analysis.
One end of each cable assembly has a molded connector, which fits into the
FSICEBASE. Leads at the other end of each cable terminate in female probe tips.
Ball clips come with the cables.
Additional Components
You can purchase other components to enhance your development efforts. You can
purchase these components separately:
• Host computer
You must provide an IBM-compatible personal computer to run the development
software.
• An emulation module (EM)
An emulation module (EM) is a printed circuit board that emulates the features of a
specific set of microcontroller units (MCUs). An EM completes the functionality of
the FSICEBASE for a particular MCU or MCU family. The FSICEBASE works
with a variety of EMs. You can purchase EMs separately from the FSICEBASE.
The two DIN connectors on the bottom of the EM fit into connectors on the top of the
FSICEBASE box. The target provides power and signal targets.
Connection to your target system is then made through a separately purchased target
cable and target head adapter that attaches to a target connector located on the top of
the EM board.
• Optional target cable
You can separately purchase a target cable that is part of a cable assembly, which is
used to connect a target system to the FSICEBASE.
• Optional target head adapter
You can separately purchase a target head adapter that is part of a cable assembly,
which is used to connect a target system to the FSICEBASE.
• Optional Bus State Analyzer (BSA) cables
The base station contains ports for three BSA pods. You can purchase BSA cables in
addition to those supplied with the FSICEBASE system.