Freescale Semiconductor Microcontrollers - Manual (Page 359)

ICS MON08 Interface Connection
Connection Procedure
359 Microcontrollers Debugger Manual
Prompt on Flash Program Checkbox
Checking Always Erase and Program Flash without asking lets the software
transparently program the microprocessor.
Trim Options
The Calculate Trim and Program the Non-Volatile Trim Register checkbox enables
automatic calculation and programming of the trim value in a designated non-volatile
memory location.
Sync to PLL Change Checkbox
Sync to PLL Change is required for the software/hardware connection to synchronize
with the microprocessor during the Flash erasing/programming procedure.
NOTE The Non-Volatile Memory Preservation and Custom Trim functionality are
only available for the M68HCS08 devices, and as such these options are
disabled for all M68HC08 devices.
Start Expert Mode Programmer Option
Start Expert Mode Programmer grants the user access to P&E’s graphical Flash
programming utility, PROG08SZ. PROG08SZ lets an advanced user control the step-by-
step execution of the Flash erase/programming procedure. See
Figure 13.10 . For more
information on using PROG08SZ, refer to P&E Microcomputer Systems website at:
www.pemicro.com.