Freescale Semiconductor Microcontrollers - Manual (Page 397)

SofTec HC08 Connection
From Within an Existing Project
397 Microcontrollers Debugger Manual
From Within an Existing Project
To take the first steps toward debugging with the CodeWarrior IDE and setting the SofTec
HC08 connection from within an existing debugging project:
1. Run the CodeWarrior IDE.
2. Open the project.
3. Choose Project > Debug to start the debugger.
4. In the Debugger, choose Component > Set Connection to select another target
interface in the Set Connection dialog box.
5. Select HC08 as Processor.
6. Select SofTec HC08 as connection.
Figure 16.2 Set Connection Dialog Box - SofTec HC08 Selection
7. In the MCU Configuration dialog box, choose the correct target processor.