Freescale Semiconductor Microcontrollers - Manual (Page 419)

HC08 FSICEBASE Emulator
Setting Up Logic Cables and Connectors
419 Microcontrollers Debugger Manual
Emulation System Reset
The debugger allows you to reset the emulation MCU and set the PC register to the
contents of the reset vector.
To reset the FSICEBASE:
1. If the FSICEBASE is connected to an emulator module (EM), specify the type of reset
available to the EM.
a. From debugger main menu, select FSICEBASE-HC08
The FSICEBASE-HC08 menu is between the Run menu and the Component
menu. If you do not see the FSICEBASE-HC08 menu, you need to specify the
connection. For more information on specifying a connection see
Specifying A
Connection .
b. Select Target Signals — Target Signals dialog box opens ( Figure 17.8 )
c. If you want to allow a reset signal coming from the target system (through the
target cable), check the Reset IN checkbox.
Some EMs include a hardware jumper that governs target resets. Make sure to
configure jumpers as necessary to use the Reset IN option. For more information,
refer to your EM’s documentation.
d. To allow a reset signal to be sent to the target system (through the target cable),
check the Reset Out checkbox.
NOTE If you check both Reset IN and Reset Out the internal resets of the emulator
system are not sent to the target system.
e. Click OK
2. From debugger main menu, select FSCICEBASE-HC08
3. Select Reset
The debugger sends a reset signal to the FSICEBASE.
Setting Up Logic Cables and Connectors
The diagram below shows the pin numbering for both pod A and pod B logic cable
connectors of the station module.
Table 17.1 shows the pinout information of the logic
clips. You can use the logic clips are used to capture data in the bus state analyzer. (Pin 9
of both pods provides connection to an external ground.) In addition, the pod connectors
are used as external clock inputs for the emulator clock and bus state analyzer timetag.
The table also provides color code information for each pod. The external clock inputs are
through pin 17 of each pod. Pod A pin 17 is the external clock input for the emulator. To