Freescale Semiconductor Microcontrollers - Manual (Page 501)

SofTec HCS08 Connection
First Steps from Within an Existing Project
501 Microcontrollers Debugger Manual
Trigger Module Settings
Select SofTec-HCS08 > Trigger Module Settings to open the Trigger Module Settings
dialog box. Refer to the Debugger HCS08 Onchip DBG Module User Interface manual
for related information.
Bus Trace
Select SofTec-HCS08 > Bus Trace to open the Trace component window within the
debugger main window. Refer to the
HCS08 On-Chip DBG Module section for related
information.
MCU Configuration Dialog Box
The Hardware Model drop down list can be expanded to select another type of BDC debug
interface than the SofTec inDART-HCS08. The HW Code drop down list can be
expanded to select another HCS08 derivative.
Figure 22.5 MCU Configuration Dialog Box
Press the Communication Settings button in this window to open the Communication
Settings Dialog Box .
Communication Settings Dialog Box
The BDC Clock (CLKSW) group is intended to setup the best BDC synchronization
between the SofTec inDART-HCS08 interface and the target processor.
When Use system bus frequency is selected, the BDC communication clock source is the
microcontroller’s bus frequency; when Use alternate frequency is selected, the BDC
communication clock source is a constant clock source, which can vary depending on the