Freescale Semiconductor Microcontrollers - Manual (Page 796)

Debugger Engine Commands
Debugger Commands
796 Microcontrollers Debugger Manual
LOAD
The LOAD command loads a framework application (.abs file) for a debugging session.
When no application name is specified, the LoadObjectFile dialog box is opened.
If no target is installed, the following error message appears:
Error: no target is installed
If no target is connected, the following error message appears:
Error: no target is connected
Usage
LOAD[applicationName] [CODEONLY|SYMBOLSONLY]
[NOPROGRESSBAR] [NOBPT] [NOXPR] [NOPRELOADCMD]
[NOPOSTLOADCMD] [VERIFYFIRST|VERIFYALL|VERIFYONLY]
[AUTOERASEANDFLASH] [NORUNAFTERLOAD|RUNANDSTOPAFTERLOAD
= functionName|RUNAFTERLOAD] [DELAY] [ADD_SYMBOLS]
Where:
• applicationName is the name of the application to load
• CODEONLY and SYMBOLSONLY loads only the code or symbols
• NOPROGRESSBAR loads the application without progress bar
• NOBPT loads the application without loading breakpoints file (with BPT
extension)
• NOXPR loads the application without playing Expression file (with XPR
extension)
• NOPRELOADCMD loads the application without playing PRELOAD file
• NOPOSTLOADCMD loads the application without playing POSTLOAD file
• DELAY loads the application and waits one second
• VERIFYFIRST matches the "First bytes only" code verification option.
• VERIFYALL matches the "All bytes" code verification option.
• VERIFYONLY matches the "Read back only" code verification option.
• RUNAFTERLOAD runs application after loading
• RUNANDSTOPAFTERLOAD runs application after loading and set
temporary breakpoint at the specified function
• functionName is the name of the function to set temporary breakpoint at
• NORUNAFTERLOAD doesn't run application after loading (default)