Freescale Semiconductor Microcontrollers - Manual (Page 798)

Debugger Engine Commands
Debugger Commands
798 Microcontrollers Debugger Manual
LOADSYMBOLS
This command is similar to the LOAD command but only loads debugging information
into the debugger. This can be used if the code is already loaded into the target system or
programmed into a non-volatile memory device.
If no target is installed, the following error message is displayed:
“Error: no target is installed”
If no target is connected, the following error message is displayed:
“Error: no target is connected”
Usage
LOADSYMBOLS [applicationName]
Components
Debugger engine.
Example:
LOADSYMBOLS FIBO.ABS
Debugging information of the FIBO.ABS application is loaded. If no path is
specified, the destination directory is the current project directory.
LOG
The LOG command enables or disables logging of information in the Command Line
component window (and to logfile, when it as been opened with an
LF command). If
LOG is not used, all types are ON by default i.e. all information is logged in the
Command Line component and log file.
NOTE RESPONSES: Responses are results of commands. For example, for the DB
command, the displayed memory dump is the response of the command.
Protocol messages are not responses.
ERRORS: Errors are displayed in red in Command Line component. Protocol
messages are not errors.
NOTICES: Notices are displayed in green in the Command Line.