Freescale Semiconductor Microcontrollers - Manual (Page 563)

RS08 Open Source BDM Connection
First Steps From Within an Existing Project
563 Microcontrollers Debugger Manual
First Steps From Within an Existing Project
To take the first steps toward debugging with the CodeWarrior IDE and setting the RS08
Open Source BDM connection from within an existing debugging project:
1. Run the CodeWarrior IDE.
2. Open the project.
3. Choose Project > Debug to start the debugger.
4. In the debugger main window, choose Component > Set Connection to select another
connection.
5. Select RS08 as the Processor then RS08 Open Source BDM as the connection.
Figure 26.2 Set Connection Dialog Box - RS08 Open Source BDM Selection
6. Click the OK button - Set Derivative dialog box typically opens (if not, you can start
debugging immediately).
7. In the Set Derivative dialog box, select your target processor.